SkullTroniX
|
Revised Bucky Skeleton/SkullTroniX Neck Mounting NotesWhen mounting the SkullTroniX on the Buck Skeleton as shown in the included instructions you may find the Skull appears set back too far. To correct this find a 4" section of 1/4" steel shaft and drive it into the front hole of the skeleton's vertebrae. The skeleton comes from the factory with a 5/16" shaft coming up the rear of the vertebrae and the smaller 1/8" shaft in the front hole. The 1/8" shaft has already been cut off so you have the 1/4" hole it was in to push the new 4" x 1/4" shaft down into. Leave 2" of the 1/4" post sticking up and mount the SkullTroiX with the large neck hole over the rear shaft and the fromt neck hole on the 1/4" shaft. This will properly align the SkullTroniX neck with the Bucky skeleton neck.
If you need the 1/4" shaft just call us. Free to all SkullTroniX owners.
Jerry Jewell
|
