[Phoenix]

In many respects the SkullTroniX talking skull led the way in the development of many modern animatronic props, however, there were some complications that prompted the development of 'something better' in terms of servo control boards.

To achieve the end result the pre DMX Skull had no less than 4 circuit boards, and if you bought the DMX pack you needed 2 USB connectors, and have a few configuration pains with VSA...... and servo burnouts were something that could happen very easily if you were not very careful

The BoC was developed to solve these issues, with a BoC skulls need just the one circuit board that controls the power, servos and LEDs, your computer only needs 1 USB connector, your lights and all other props connect to the single DMX chain, VSA needs virtually no configuration and the most significant improvement is the ability to program limits of motion on the servo control board which has virtually eliminated servo burnout.