SkullTroniX (tm) Support Forum Index SkullTroniX (tm) Support
Technical support and discussion of SkullTroniX (tm) products
 
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   Join! (free) Join! (free) > 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

Revised Bucky Skeleton/SkullTroniX Neck Mounting Notes

 
Post new topic   Reply to topic    SkullTroniX (tm) Support Forum Index -> SkullTroniX Animatronic Skulls
View previous topic :: View next topic  
Author Message
Please Register and Login to this forum to stop seeing this advertsing.
Posted:     Post subject:
Back to top
SkullTroniX
Site Admin


Joined: 23 Apr 2007
Posts: 41


Location: Rancho Cordova CA USA
PostPosted: Sun Jun 03, 2007 8:36 pm    Post subject: Revised Bucky Skeleton/SkullTroniX Neck Mounting Notes Reply with quote
When mounting the SkullTroniX on the Buck Skeleton as shown in the included instructions you may find the Skull appears set back too far. To correct this find a 4" section of 1/4" steel shaft and drive it into the front hole of the skeleton's vertebrae. The skeleton comes from the factory with a 5/16" shaft coming up the rear of the vertebrae and the smaller 1/8" shaft in the front hole. The 1/8" shaft has already been cut off so you have the 1/4" hole it was in to push the new 4" x 1/4" shaft down into. Leave 2" of the 1/4" post sticking up and mount the SkullTroiX with the large neck hole over the rear shaft and the fromt neck hole on the 1/4" shaft. This will properly align the SkullTroniX neck with the Bucky skeleton neck.

If you need the 1/4" shaft just call us. Free to all SkullTroniX owners.

Jerry Jewell
_________________
Jerry Jewell
Owner, SkullTroniX
916 600-2295
Back to top
View user's profile Send private message Send e-mail Visit poster's website
icemanfred



Joined: 02 Aug 2008
Posts: 27
PostPosted: Mon Oct 06, 2008 2:54 am    Post subject: Reply with quote
the rear hole has the wires coming out.wouldnt it be a bad idea to try to mount onto the shaft. wouldnt you run a risk of damaging the wires?
Back to top
View user's profile Send private message
Display posts from previous:   
Post new topic   Reply to topic    SkullTroniX (tm) Support Forum Index -> SkullTroniX Animatronic Skulls All times are GMT - 8 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum

Card File  Gallery  Forum Archive
Powered by phpBB © 2001, 2005 phpBB Group
Create your own free forum | Buy a domain to use with your forum